Consultation & Film Selection
- Client consultation:
- Desired appearance (5 – 50%)
- Film options (carbon or ceramic)
- Legal limits based on local laws
Vehicle Preparation
- Inspect windows: Check for chips, scratches or defects.
- Remove obstructions (if needed):
- Interior panels, seals, third brake light
- Thorough cleaning:
- Remove dirt and contamination from exterior and interior glass surfaces (tint is applied on the inside of the window).
Film Preparation
- Cut film:
- Manually (hand-cut) or template (plotter).
- Heat shrinking:
- Use a heat gun and hard card/squeegee to shrink and contour the film to match the window curve.
Film Application (Installation)
- Spray application solution:
- A mixture of slip solution is sprayed on the inside of the window to allow repositioning and smooth application of the film.
- Install film on inside of window:
- Squeegee out water and air from behind the film.
- Edge trimming:
- Final trim and seal around the edges with precision blades.
Final Touches
- Post-heating (where applicable):
- Use heat gun to dry and set the film, minimizing water bubbles and lock-in the shape of the glass.
- Final edge work:
- Check corners for lift or gaps.
Curing & Aftercare Instructions
- Client instructions:
- Don’t roll down windows for 3–5 days. Bubbles & haziness are normal during this period.
- Avoid cleaning with ammonia-based cleaners (use a microfiber towels and tint safe glass cleaner).
Glow Auto Studio 